JVC HM-DH30000U - Manual (Page 16)

16
EN
CABLE BOX SET UP
OFF
PRESS ( 2 3), THEN (OK)
PRESS (MENU) TO END
Turn on the VCR and the TV, and select the AV
mode on the TV.
Setting cable box output
channel & brand
After installation, set the cable box output’s channel and
its brand correctly; otherwise, the Controller cannot
work correctly.
1
Turn on cable box
Select a channel other than channel 9 on your
cable box.
2 Access Main Menu screen on VCR
Press MENU.
3
Access Tuner Set Up screen
Press %fi to move the highlight bar (arrow) to
“TUNER SET UP”, then press OK.
4 Access Cable Box Set screen
Press
%fi to move the
highlight bar (arrow) to
“CABLE BOX SET UP”,
then press OK.
5 Select cable box output channel
Your selection depends
on how your cable box
is connected to your
VCR.
● If your cable box is
connected to your
VCR’s ANTENNA IN
terminal on the rear panel
Press
@ # until the channel number
representing the cable box’s output (CH2 –
CH9) appears on the screen.
● If your cable box is connected to your VCR’s
AUDIO/VIDEO IN connectors on the front panel
Press
@ # until “ON F-1 (FRONT)” appears on
the screen.
● If your cable box is connected to your VCR’s
AUDIO/VIDEO IN (L-1) or AUDIO/VIDEO IN
(L-2) connectors on the rear panel
Press
@ # until “ON L-1 (REAR)” or “ON L-2
(REAR)” appears on the screen.
● If you do not use a cable box
Press @ # until “OFF” appears on the screen.
1 2 3
4 5 6
7 8 9
0
VCR TV CABLE/DBS
2
3 4
3 4
6 7
INITIAL SETTINGS (cont.)
TUNER SET UP
BAND CATV
AUTO CHANNEL SET UP
MANUAL CHANNEL SET
GUIDE CHANNEL SET
3 CABLE BOX SET UP
DBS RECEIVER SET UP
PRESS (
5∞), THEN (OK)
PRESS (MENU) TO END
7
5