John Lewis JLTDH14 - Manual (Page 19)

Clean operating screen
and housing
Caution! Do not use furniture
cleaners or aggressive cleaning agents
to clean the machine.
Use a damp cloth to wipe down the
operating screen and housing.
What to do if ...
Problem 1) Possible cause Remedy
Dryer does
not work.
Dryer not connected to mains supply.
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Loading door opened. Close loading door
The Start/Pause button not pressed. Press the Start/Pause button.
Unsatisfactor
y drying
results.
Incorrect programme set. Set suitable programme.
2)
Fluff filters clogged. Clean fluff filters. 3)
Heat exchanger clogged. Clean heat exchanger. 3)
Max. loading exceeded. Respect max. loading volume.
Covered ventilation grill. Uncover ventilation grill in base area.
Residue inside the drum. Clean the drum inside.
High water hardness. Set suitable water hardness 4) .
Loading door
does not
close
Filters not locked in place.
Install fine filter and/or snap course filter
into place.
Red flashing
the Start/
Pause LED
Attempt to change parameters after start
of the programme. Turn the dryer off and on. Set requested
parameters.
No drum
light
Programme selector in Off position. Turn it to any programme.
Defective light bulb. Replace light bulb (see next section).
Programme
inactive
Full water reservoir.
Empty water reservoir 3) , press Start/
Pause button.
Drying cycle
to short Small laundry volume./Too dry laundry
for selected programme. Select time programme or higher drying
level (e.g. Extra dry ).
19