Multi-brand remote control, Tv brand setting, The av mode – JVC D-VHS User Manual
Page 76: Turn on the tv, Set remote operation mode, Set tv brand code, Operate tv
Masterpage:Left-FullCol
76
EN
Filename [HM-DH5U_Eng.fm]
MULTI-BRAND REMOTE CONTROL
TV Brand Setting
When programmed (set) with a manufacturer’s (brand’s)
code, this Remote can perform some of the remote
control functions of the listed TVs. You can control a JVC
TV without setting a brand code.
A
Turn on the TV
Turn on the TV using the Power button on the TV
or its Remote.
B
Set remote operation mode
Set the [VCR/TV/CABLE/DBS] selector to [TV].
C
Set TV brand code
Follow the example shown below.
A Press and hold [POWER].
B Press the ‘Number’ keys to enter your TV’s
brand code by referring to the table below.
C Press [STOP (L)], and release [POWER].
•
Once you have set the Remote to operate the
TV, you do not have to set it until you replace
the batteries from the Remote.
•
JVC and PANASONIC have two codes. If the TV
does not function with one code, try entering
the other.
D
Operate TV
Press one of the following buttons:
[POWER], [TV/VCR], [TV/VCR CH +/–], [c/d]
(TV Muting), [TV VOL +/–], and ‘Number’ keys.
•
For some brands, you must press [ENTER] after
having pressed the ‘Number’ keys to enter a
channel number.
•
To operate the VCR, set the [VCR/TV/CABLE/
DBS] selector back to [VCR].
NOTES:
•
Depending on the type of TV, some or all functions cannot be
operated using this Remote.
•
It’s not possible to operate a TV not equipped with a remote
sensor.
TV BRAND NAME
BRAND CODE
JVC
HITACHI
MAGNAVOX
MITSUBISHI
PANASONIC
RCA
SHARP
SONY
SAMSUNG
SANYO
SEARS
TOSHIBA
ZENITH
01, 03
10
02
03
04, 11
05
06
07
12
13
13
08
09
[TV/VCR]
[TV/VCR
CH +/ ]
[TV VOL
+/ ]
[
c
/
d
]
[ENTER]
C
- C
C
- B
D
Number keys
C
- A,C
D
B
VCR
TV
CABLE
/DBS
(E.g.) To set Remote to RCA 05:
POWER
AUX
JKL
STOP
Hold
down
Press in succession
Release
HM-DH5U_Eng.fm Page 76 Friday, June 25, 2004 11:42 AM