JVC KD-APD38 - Manual (Page 160)

16
ENGLISH
External component
operations
You can connect an external component to the AUX
(auxiliary) input jack on the control panel.
~
Ÿ
Turn on the connected component and
start playing the source.
!
Adjust the volume.
⁄
Adjust the sound as you want. (See
page 13.)
To check other information while listening
to an external component
Clock Ô AUX IN
Maintenance
How to clean the connectors
Frequent detachment will deteriorate the connectors.
To minimize this possibility, periodically wipe the
connectors with a cotton swab or cloth moistened with
alcohol, being careful not to damage the connectors.
Moisture condensation
Moisture may condense on the lens inside the unit in
the following cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the unit may malfunction. In this
case, eject the disc and leave the unit turned on for a
few hours until the moisture evaporates.
How to handle discs
When removing a disc from its
case, press down the center holder
of the case and lift the disc out,
holding it by the edges.
• Always hold the disc by the edges. Do not touch its
recording surface.
When storing a disc into its case, gently insert the
disc around the center holder (with the printed surface
facing up).
• Make sure to store discs into the cases after use.
Connector
Center holder
EN14-23KD-PDR35_001A_pre.indd 16 EN14-23KD-PDR35_001A_pre.indd 16 11/16/06 5:56:08 PM 11/16/06 5:56:08 PM