JVC KD-APD38 - Manual (Page 171)

3
A Typical connections /
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious
damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1 Connect the colored leads of the power cord in the order specified in the illustration below.
2 Connect the antenna cord.
3 Finally connect the wiring harness to the unit.
ENGLISH
ELECTRICAL CONNECTIONS
* 1 Not supplied for this unit.
* 2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power
cannot be turned on.
Line out (see diagram )
Rear ground terminal
iPod jack
(see diagram )
iPod
15 A fuse
15 A
Antenna terminal
Blue with white stripe
To the remote lead of other equipment (200 mA max.)
200 mA
1
2
3
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
12 V
To an accessory terminal in the fuse block
Black
Red
Yellow * 2
* 2
Ignition switch
Fuse block
Purple Purple with black stripe Green Green with black stripe Gray Gray with black stripe White White with black stripe
Right speaker (rear) Left speaker (rear) Right speaker (front) Left speaker (front)
* 1
* 2
Blue
To the automatic antenna if any (250 mA max.)
250 mA
Loop (see diagram )
Install2_KD-PDR35_2.indd 3 Install2_KD-PDR35_2.indd 3 2006.12.19 2:50:36 PM 2006.12.19 2:50:36 PM