Troubleshooting – JVC KD-APD38 User Manual

Page 172

Advertising
background image

4

Connecting the external amplifier or subwoofer

/

B

You can connect amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it

can be controlled through this unit.

Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker

leads of this unit unused.

Remote lead (blue with white stripe)

To the remote lead of other equipment or automatic antenna if any

Front speakers

Set “L/O MODE” to “WOOFER” (See page 15 of the
INSTRUCTIONS.)

L/O MODE

WOOFER

15

Subwoofer

Rear speakers

or

Y-connector (not supplied for this unit)
Y-

*

3

Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint
(if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the
unit.

*

4

Remote lead

*

5

Signal cord (not supplied for this unit).

TROUBLESHOOTING

The fuse blows.
* Are the red and black leads connected correctly?

Power cannot be turned on.
* Is the yellow lead connected?

No sound from the speakers.
* Is the speaker output lead short-circuited?

Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?

Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?

This unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?

This unit does not work at all.
* Have you reset your unit?

JVC Amplifier

JVC

Set “L/O MODE” to “REAR” (See page 15 of the
INSTRUCTIONS.)

L/O MODE

REAR

15

C

Connecting an Apple iPod

/

Apple iPod

Connection cable for iPod (supplied)

iPod

Apple iPod (separately purchased)

Apple iPod

You can connect an iPod to this unit using the supplied connection cable for iPod.
1 Insert the supplied cable tie across the loop.
2 Press in the head of the connection cable for iPod until you hear a clicking sound.
3 Fasten the connection cable using the cable tie to firmly hold the connection cable in place.

iPod

iPod

1
2

iPod

3

iPod

iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
iPod

Apple Computer, Inc.

*

3

*

4

*

5


*


*


*


*
*

L

R


*


*
*

L

R


*

JVC Amplifier

JVC

Cable tie

Loop

Install2_KD-PDR35_4.indd 4

Install2_KD-PDR35_4.indd 4

2006.12.21 11:20:43 AM

2006.12.21 11:20:43 AM

Advertising
This manual is related to the following products: