Jackson AJ-44 - Manual (Page 42)

AJ-44C Series Technical Manual 7610-001-76-22
Issued: 03-21-2006 Revised: N/A
SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
CHANGING THE AJ-44CE/CS DIRECTION OF TRAVEL
34
The AJ-44 dishmachine has the ability to have its
direction of travel changed from left to right, or from right to
left. Direction of travel is determined by which end the rack of
ware is put into the machine and which end the rack comes
out.
There may come times when it is necessary to
change the direction of travel after the unit is installed. The
instructions provided here are for maintenance personnel only.
Unauthorized persons should not attempt any of the steps
contained in these instructions.
Warning: many of the instructions and steps
within this document require the use of tools and may
also require that personnel change the wiring of the
machine. Only authorized personnel should ever perform
any maintenance evolution on the dishmachine!
PREPARATION
1. Power must be secured to the unit at the service
breaker. Tag or lock out the service breaker to prevent acci-
dental or unauthorized energizing of the machine.
2. Disconnect incoming water at the water pressure
regulator or Y-strainer.
3. Disconnect the service drain line from the drain
plumbing of the dishmachine itself. Ensure that the unit is
completely drained before doing this.
4. Remove the locking screw from the control box.
5. Remove the front dress panel.
TOOLS REQUIRED
The following tools will be needed to perform this
maintenance evolution:
1. 5/16” nutdriver
2. 7/16” nutdriver
3. 7/16” combination wrench
4. 7/16” socket with drive ratchet and 4” extension
5. 12” pipe wrench
6. 10” adjustable wrench
7. Wire cutters
8. Phillipshead screwdriver
TIME REQUIRED
It is estimated that it will take (1) person three hours
to perform this task, not including all of the items indicated in
the section entitled “PREPARATION”.
IMPORTANT NOTES
1. Do not lose hardware! Place hardware in a safe
spot away from the machine, ensuring that it does not fall
loose into the machine tub. Hardware that is drawing into the
suction of the wash pump will damage the equipment. If you
do need more hardware, contact your JACKSON representa-
tive to purchase new items.
2. Read these instructions thoroughly before attempt-
ing this maintenance evolution. Become familiar with the parts
and what actions need to be taken. This will save time in the
long run!
STEPS
1. Remove the upper wash arm assembly by loosening the
spin nut. The spin nut has a stop so it will not come off. Once
it is loosened, the wash arm assembly should slide off.
2. Remove the end cap from the wash arm assembly and
place in the opposite end, securing it snugly.
3. With the end cap securely in the opposite end of the wash
arm assembly, set the assembly gently to the side. Go back
inside the unit to where the upper wash arm assembly secured
in the unit and turn the spin nut so that it is all the way down.
This needs to be done because in a further step, if the spin nut
is out, it will get in the way. Do not over-tighten the spin nut as
it only needs to be out of the way, not secured.
Spin nut
End cap