JVC VN-C11 - Manual (Page 15)

15
Installing the Camera
[Fall Prevention] WARNING
• Special care is required if the camera is installed on a wall or ceiling. You should not attempt
to install it by yourself as it may cause injury or an accident. This installation work should be
carried out only by qualified and experienced personnel.
• When the camera is attached to a fixer or a pan/tilt unit, use the holes for fall prevention to
secure it.
• To prevent the camera from falling off, secure it to a secure and stable structure such as a
ceiling slab or a channel by using a wire.
• Ensure that the length, strength, routing and material (insulation) of the securing wire to be
used are appropriate.
• To attach the securing wire, use the black screw on the top side of the camera.
• For fixing the wire, a screw of M2.6 X 4mm should be used. Do not use a longer screw as it
may damage the internal parts of the camera.
2 mm
4 mm
M2.6 x 4 mm
Securing wire
MAX.
7 mm
Caution
● The length of the screw for
mounting the camera must
not exceed 7 mm. Do not
use a longer screw as it
may damage the internal
parts of the camera.
● In the factory setting, the
bracket is attached on the
top of the camera. For attaching it at the
bottom, remove the two screws fixing the
bracket.
Caution
For fixing the bracket, screws of the length
of 6 mm should be used. Do not use a
longer screw as it may damage the internal
parts of the camera.
Fall-Preventive wire
For attaching the camera to a fixer or a rotating platform, use the screw hole of the
mounting bracket.
Fall-preventive holes Screws for the bracket
[x 2: M2.6 x 6 mm]
Camera mounting
screw hole
Camera-mounting bracket
VN-C10_E_01-24.pm6e 03.4.24, 10:02 AM 15