JVC VN-C11 - Manual (Page 23)

23
Note
For connecting VN-C11 with the factory settings, either one of the environments described
below is required.
• Environment where no DHCP server exists.
• Environment where a DHCP server, which clearly defines the IP address and MAC address
allotted to VN-C11, exists.
The connected camera can be registered with the installed [V.Networks Controller].
1.
Select [Start], [Programs], [V.NETWORKS] and then [V.Networks Controller] to start
up [V.Networks Controller].
Registering the Connected Camera with V.Networks Controller
Select [File] and [New].
Enter [V.Network Name], a name under which
the camera is registered. Use a name that is
easy to remember, such as the installation
location or number. (1 to 40 characters)
Note
In a DHCP environment, enter the IP
address allotted by the DHCP server.
Enter 198.168.0.2 in [IP Address].
2.
[New] is displayed.
Recording files of the name given in are
saved in a designated folder here.
You can set whether VN-C11 automatically
starts recording upon connection.
VN-C10_E_01-24.pm6e 03.4.24, 10:03 AM 23