ScyTek Electronics VISIONGUARD 8000 - Manual (Page 10)

Page 6 - VisionGaurd 8000
Programable Functions using the LCD Transmitter
Pressing and holding transmitter button 4 will scroll through several transmitter
programable options.
CHIRP To set the siren’s confirmation chirps ON or OFF:
1.Press and hold button 4 until the icon “chirp” appears.
· The transmitter will beep twice.
2.Release button 4
· The transmitter will beep once.
· The transmitter will display a SIREN for “chirps on”, or OFF for “chirps off”.
SOUND To set the transmitter’s confirmation tone ON or OFF:
1.Press and hold button 4 until the icon “SOUND” appears.
· The transmitter will beep three times.
2.Release button 4
· The transmitter will beep once.
PASSIVE To set passive mode ON or OFF:
1.Press and hold button 4 until the icon “PASSIVE” appears.
· The transmitter will beep four times.
2.Release button 4
· The transmitter will beep once.
· The transmitter will display “CHIRP ON” for on, or “CHIRP OFF” for off.
NOTE: SHOCK ,TURBO, SENSOR 1 AND SENSOR 2 ARE NOT USED.
VALET To set the VALET mode ON or OFF:
1.Press and hold button 4 until the icon “VALET” appears.
· The transmitter will beep 7 times.
2.Release button 4
· The transmitter will play a melody for ON or display “DISARM” for off.
DRIVER CALLING/PAGE FEATURE
The Vision Gaurd 8000 is equipped with a driver calling or paging feature that allows the system to send
a page to the LCD transmitter in the event the transmitter has been misplaced or lost (within 1500 feet)
To activate the DRIVER CALLING/PAGE feature:
1.Locate the VALET/EMERGENCY OVERRIDE button in your vehicle (Ask your installation shop)
· With the ignition switch OFF, press and hold the valet/emergency override button for 2
seconds, then release.
· The LCD transmitter will beep continually and the “DRIVER CALLING” icon will appear.
· Press and release button 4 to turn off transmitter page.