ScyTek Electronics VISIONGUARD 8000 - Manual (Page 18)

Page 14- VisionGaurd 8000
Turbo Timer Feature
The Turbo Timer feature allows vehicles with turbocharged engines to remain running after the ignition key
is removed, for proper cool-down of the turbocharger. The Turbo Timer feature requires connection to the
vehicle’s parking brake wire.
To activate the Turbo Timer feature:
1. Leave the engine running after parking the vehicle.
2. Set the vehicle’s parking brake.
· The Turbo Timer will begin a two-minute run cycle to allow the turbocharger to cool down.
3. Turn OFF the ignition and exit the vehicle.
To deactivate the Turbo Timer feature:
1. Turn ON the ignition.
2. Press the brake pedal.
· The Turbo Timer countdown will automatically stop and the engine will shutdown.
WARNING: the Turbo Timer feature is not intended for use inside garages or other non-ventilated areas.
Make sure to deactivate the Turbo Timer feature when parking in such areas.
Model: VisionGuard 8000-M
1- Tach wire must be connected , The system must learn RPM.
2- Hand brake must be connected.
3- Door trigger must be connected
4- Clutch override installed NOTE: MUST USE A RELAY TO BYPASS CLUTCH SWITCH!!
Remote Starting
With engine running and Hand-brake engaged put the vehicle transmission in neutral and remove the foot
from the brake pedal, press remote start button on your transmitter, parking lights will flash twice and stay
on indicating Manual Start Mode is enabled, turn off the Ignition switch, the engine will remain running.
Open and close the door, the system will shut the engine Off. Using the remote Control to arm the vehicle.
Vehicle is now ready for remote start operation.
Starter Ready Mode is canceled any time the door is opened; hand brake is released or any
other error condition.
To Remote Start the System:
1. Be sure the system is not in Valet Mode.
2. Press and hold Button 4 for three seconds.
· The parking lights will turn on.
· The engine will start and run for the duration of its programmed Run Time.*
· The heater or air conditioner will turn on (if turned on prior to exiting the vehicle).
*If the engine fails to start on the first attempt, it will repeat the starting procedure 2 more times. If the vehicle
fails to start after a total of 3 times the parking lights will flash 4 times and the doors will lock (if installed).
Turn on the ignition and press the brake pedal to disengage the remote start feature and drive the vehicle.
Shut Down
When the the Remote Start feature is active, any of the following actions will shutdown the engine:
1. Pressing Button 4.
· After the engine shuts down the doors will lock (if installed).
2. Pressing the Brake Pedal.
3. Opening the Hood.
4. Remote Start Time-Out (completion of the timed run cycle).
5. Emergency Brake Off.
Manual Transmission Remote Start Features