ScyTek Electronics VISIONGUARD 8000 - Manual (Page 28)

Page-24 VisionGaurd 8000
Diesel Engine. Sets the engine type for Diesel and monitors the glow plug input to make sure the glow
plugs are warm before cranking the starter. If the glow plug wire is not connected, the built-in timer
waits 15 seconds before automatically cranking the starter.
22. Ignition 2 Relay Program. Selects one of three operating modes for the Ignition 2 relay output:
Ignition 2, Accessory 2, or Starter 2.
23. Horn Output. When set for Horn Output the horn wire will pulse when the alarm is triggered. When
Ignition 3 Output is selected, the output will activate during remote start to trigger a relay for Ignition 3.
24. Turbo Timer. When enabled, if the emergency brake has been applied Ignition power will be kept On
for a predetermined time (2min. Factory Default) from the application of the emergency brake.
25. Extended Parking Lights. When Enabled, upon Disarming Parking lights will turn On for 30 seconds
or untill the Dome light turns Off.
26. Warn-Away Pager Report. When Enabled, Warn-Away report will be sent to the pager. If Disabled
no Warn-Away report will be sent to the pager.
27. Factory Rearm Function. Camera Flash Mode- pulses Factory Rearm output for 1 second every time
the camera is activated. Factory Rearm Mode - enables the output to operate as a Factory Rearm
output.
28. Zoom Mode. Picture Zoom Mode- select zoom 1X, 2X, 4X
29. Picture Orientation. Select Normal or Inverted