Sony TC-KB920S - Manual (Page 5)

Basic Operations
5 EN
Basic Operations
Playing a Tape
1 Turn on the amplifier and select the tape deck position.
2 Press POWER, and then press §.
Insert a cassette and close the cassette holder.
“TAPE” and the tape type (I, II, or IV) appear in the display.
• See page 4 for hookup
information.
Basic Operations
Take out the cassette
To Press
Stop playing p
Pause P PAUSE. Press the button again to
resume playback.
Fast-forward or rewind ) or 0 when the deck is stopped
) or 0 again during fast-forwarding
or rewinding Increase the tape fast-forward or rewind
speed
§ after stopping playing
3 Press ·.
The deck starts playing. Adjust the volume on the amplifier.
Do not press POWER or § while the tape deck is operating.
If you do so, the tape may be damaged.
With the side you want to play
facing you
z
To play a tape recorded
with the Dolby NR*
system
Turn DOLBY NR to the same
Dolby system that the tape
was recorded in—B, C, or S.
Please note that the B, C, and
S settings on both sides are
identical during playback
since the MPX filter operates
only during recording.
z
You can connect the
headphones to PHONES.
* Dolby noise reduction
manufactured under license
from Dolby Laboratories
Licensing Corporation.
“DOLBY” and the double-D
symbol a are trademarks of
Dolby Laboratories Licensing
Corporation.
R ® §
º ‚
REC MUTE PAUSE REC
π
·
OFF
L R
MPX
FILTER
DOLBY NR BALANCE CALIBRATION
EJECT MONITOR
REC LEVEL
0
1
2
3
4 5
6
7
8
9
10
MEMORY C C
B B
S S
AMS AMS
∏
RESET COUNTER
L R
CAL REC LEVEL
L R
BIAS
PHONES
3
2
U