SoundFreaq SFQ-01 - Manual (Page 14)

.13.
 Please check the user manual of the iPad or
Bluetooth-enabled device with which you
are initiating pair to learn about Bluetooth
connection with any other devices.
4. Once the unit is detected and its name
"Sound Platform" appears on the display of
your iPad or Bluetooth-enabled device, key
in the default password "1234" if a prompt
requests it.
 You may change the device name on your
Bluetooth-enabled device after the pair is
successfully set up.
 The pair indicator starts blinking quickly to
indicate that the unit and your device have
put into the connection mode.
 When a Bluetooth connection is established
successfully, the indicator starts blinking
slowly.
 If the Bluetooth connection is completed in
the Bluetooth display, and a prompt chime
will sound.
5. Select Bluetooth mode by repeatedly pressing
the SOURCE button on the unit or remote
control.
6. Select the desired music and press "Play"
button on your device. The unit automatically
starts playing the audio.
 Try again above steps 2 to 5 if the Pair
indicator on the unit lights solidly.
Using multiple Bluetooth devices:
Only one device can be used at a time, but you
can switch between different Bluetooth devices.
Make sure each device you want to use has
already been paired, to switch devices:
1. On the Sound Platform, press the pair button
2. On the Bluetooth device, select connect to
the Sound Platform.
This device is now the connected device to the
Sound Platform (the previous connected device is
now disconnected). Repeat those steps to
switch the connected device again.
Note: If the unit has no sound output, please
check if the volume level of your Bluetooth
device connected to the system is set to the
minimum, or the Bluetooth device is muted.
Playing back from Macbook or Macbook Pro:
1.
In the desktop screen, Select the “Open
Bluetooth Preference”.
2. If there is any old “Sound Platform” records,
remove it. And then select “Setup New
Device” again.
3. Select “Sound Pla” and the type should be
“Audio” in the latest SFQ-01 unit.
Click the “Continue” to proceed pairing
process.
4. Once completed, the pairing success screen
will come out.
Note: Don’t quit the page immediately. You
may notice that the previous dialog screen
still shows the device not connected. Just
ignore it. It’s confusing to the user. In fact,
it’s connected already.
5. Open iTune, play a song. Then use mouse to
click the Bluetooth icon and the top right
hand corner of the desktop screen, select
the “Sound Platform” option and then select
the “Use as Audio Device (Stereo)”. After a while
(a few seconds), the music will come out
from the SFQ-01. If not, retry to select the “Use
as Audio Device (Stereo)” once again. The
Sound Quality should be good.
Playing Back from PC/Notebook:
1. Press the “Start” button to open the “Device
and Printers” dialog box.
2. Turn on the SFQ-01 system and press the
PAIR button on the unit to put the unit into
the pair mode.
3. Select the “Add a device” in the “Device and
Printer” dialog box. The “Sound Platform”
icon will appear on the display.
4. Double click the “Sound Platform” icon and
wait until the device has been added
successfully.
5. Click the “Close” button to close the “Device
and Printer” dialog box. A ”Sound Platform”
icon appears in the dialog box.
6. Double click the “Sound Platform” icon and
the device connection screen will be shown.
7. Click the “Connect” button in the “Music and
Audio” option.
8. Once connected, the pair indicator on the
unit will blink slowly and the connection
success screen will be shown.