SoundFreaq SFQ-01 - Manual (Page 16)

.15.
5. Use " "/ " " on the unit or remote control
to select the channel number (from 01 to 20)
to be set.
6. Press " " button again to store the frequency.
The selected frequency will then be stored
with the preset channel number.
 The "SAVED" is displayed during the saving
operation.
 The display will be switched automatically to
channel number display after a few seconds.
A. Manual Tuning - Briefly press " "/ " "
button repeatedly to move frequency to
frequency (from 87.5 MHz to 108.0 MHz)
until you find the desired station.
B. Auto Scanning - Hold " "/ " " button
until the frequency display starts flashing.
The frequency will be scanned automatically
until a station is found.
4. Hold " " button to start storing a station.
 The channel number shows on the display.
LCD Display
LCD Display
LCD Display
LCD Display
LCD Display
LCD Display
1. Turn the unit power on.
2. Set the volume to the minimum position.
3. Select AUX mode with the SOURCE button.
4. Start playback on the external device.
5. Adjust the volume level to the level that you
want to listen to.
Note: Volume level will be shown on the display
in the process of adjustment.
Playing back from External Source
Listening to an External Audio
Device, Digital Music Player or Any
Other Audio Source
Connect an external device to the AUX IN jack
on the back panel of the unit using a stereo
mini plug cord (not supplied).
Back Panel
To audio output such
as CD/MD/ digital
music player, etc.