SMC Networks SMCWEBT-G - Manual (Page 21)

9
EZ I
NSTALLATION
W
IZARD
To configure your SMCWEBT-G, first verify that your computer
has an IP address in the same subnet as the SMCWEBT-G. If you
are not familiar with this procedure, see the “Using IPCONFIG”
section below.
Note: The default IP address of the SMCWEBT-G is
192.168.2.25
1. Insert the SMC EZ Installation Wizard & Documentation CD
into your CD-ROM drive.
2. The EZ Installation Wizard will appear. Click Configuration
Utility to begin the utility installation and setup process.