Sharp VC-MH835HM - Manual (Page 18)

16
www.sharp.co.uk/support
BASIC OPERATION
DIRECT TV RECORDING
This feature can only be used with nexTView, Smart Link, Easy Link
and Megalogic compatible tv’s.
By pressing the DIRECT TV REC button on the remote control, the VCR will record the
signal currently being displayed on the TV regardless of the signal source.
This feature can be started when the VCR is in STANDBY or OPERATE mode.
• If appears on the VCR display, press the TIMER ON/OFF button before starting.
• Ensure a video tape is inserted in the VCR.
1. To start the recording, press then release the DIRECT TV REC button.
2. To pause during recording, press PAUSE/STILL .
3. To continue recording, press REC .
4. To stop recording, press STOP once.
NOTES:
TIMER RECORDING
It is possible to program the VCR using three different methods:-
1. NexTView
2. VIDEO Plus+
3. Manually (DELAYED RECORDING)
HOW TO USE NexTView TO MAKE A RECORDING
• If the Timer Standby symbol appears on the VCR display, press the TIMER
ON/OFF button before starting.
• Check that the clock is displaying the correct time.
Some broadcasts transmit an Electronic Program Guide (EPG) in which case, using the TV
controls, the program you wish to record can be selected and used to program the VCR
automatically. This feature is compatible with NexTView TV’s. Refer to your TV operation manual
for further information. After transfer of the timer information to the VCR, the timer menu will be
displayed for approximately 5 seconds, after which press the TIMER ON/OFF button
once to place the VCR in STANDBY mode. will be shown on the display.
NOTES:
• A fully wired scart must be used for DIRECT TV RECORD operation.
• If DIRECT TV RECORD could not start, the TV should indicate the reason why.
(Refer to the TV operation manual).
• The timer menu will not be displayed if this procedure is carried out while the VCR is in
STANDBY mode.
• VPS/PDC is a signal broadcast by some TV stations which adjusts the start and stop time
of your VCR recording. This ensures that if there is a change in broadcast time for your
programme the VCR will still record the whole programme. It is essential that the start
time as it appears in the TV listing is used to program the VCR, as this information is used
to identify the VPS/PDC signal corresponding to your programme.
• If the symbol flashes a video tape has not been inserted into the VCR.
• During recording, press the STOP button to cancel the recording. If there are
further recordings to be made, the VCR will return to Timer Standby.
TINS-A082UMN1.book Page 16 Monday, November 4, 2002 2:33 PM