Sharp VC-MH835HM - Manual (Page 36)

34
www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
• It should not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
To manually tune in a channel follow the procedure below.
Ensure the Video channel is selected on the TV.
1. Press the MENU button. Press the
[ / ]menu select buttons to select
SET UP. Press the SET button to
confirm.
2. CHANNEL PRESET will be
highlighted. Press the SET button to
confirm.
3. MANUAL TUNING will be
highlighted. Press the SET button to
confirm.
4. PRESET will be highlighted. Press
the[ / ]menu select buttons to
choose the required VCR preset channel.
5. If you have SATELLITE CONTROL set to ON,
continue from point 6. Otherwise
continue from point 7.
6. Press[ / ]to select SOURCE . Then
choose the required source:
• If you wish to tune a satellite or cable
channel press [ / ] to select SAT .
Then press[ / ]to select
CHANNEL . Enter preset satellite
channel using the NUMBER
BUTTONS or by using the [ / ]
buttons step through each preset satellite
channel until the desired channel is
displayed. Continue from point 10 .
• If you wish to tune a terrestrial channel
press [
/ ] to select CH.
Continue from point 7 .
S E T U P
C H A N N E L P R E S E T
C H A N N E L S OR T
C L OC K
P O S T COD E
➔ P R E S E T BBC 1 1
SOURC E CH S A T
CHANN E L CH 2 1
F I N E T UN I NG ▲
▲
D E COD E R ON O F F
S K I P ON O F F
MENU SELECT
BUTTONS
MENU
SET
REMOTE CONTROL
2.
SET
SET
SET
TINS-A082UMN1.book Page 34 Monday, November 4, 2002 2:33 PM