Siemens 2010 - Manual (Page 7)

– 7 –
- English -
19.04.2000 euroset 2010,IM1, A31008-E2010-B100-2-3S19 2010-
❏ Switching the dialing mode
❏ Switching the dialing mode while connected
If your telephone is set to pulse dialing and you want to use functions that
require tone dialing (e.g. remote replay on an answering machine), you can
switch the dialing mode while connected.
Replacing the receiver resets the telephone to the original dialling mode.
❏ Recall key (use on private PABXs)
During a trunk call, you can make an enquiry call or transfer a call. To do
this, press the recall key
2 . The next step depends on your PABX. In the
factory setting, the recall key function is set to a flash time (interrupt time)
of 90 ms to permit new features to be used on p
public telephone systems.
When your telephone is connected to a private PABX, it may be necessary
to change the flash time (e.g. 600 ms). Please check the operating instruc-
tions for your PABX.
Setting the flash time for the recall key
> "  Lift the handset, then start the function.
 or  1 = Tone dialing,
2 = Pulse dialing without flash function.
" < Press the set key, then replace the handset.
While connected: press the asterisk key.
The dialing mode is switched.
J Enter the digits for remote control/ data transfer.
>" Lift the handset then start the function.
 ... 
Enter the required flash time number:
0:
90 ms (factory setting); 11: 120 ms,
2: 270 ms; 33: 375 ms, 44: 600 ms.
" < Press the set key, then replace the handset.