Sony DVP-NS700P - Manual (Page 75)

Se
ttings
a
nd Adjus
tme
nt
s
75
x DIGITAL OUT
Selects if DTS signals are output via the
DIGITAL OUT (OPTICAL or COAXIAL)
jacks.
Switches the method of outputting audio
signals when you connect the following
component using an optical or a coaxial
digital cord via the DIGITAL OUT
(OPTICAL or COAXIAL) jacks.
— Amplifier (receiver) with digital input
jack
— Amplifier (receiver) with a built-in DTS or
DOLBY DIGITAL decoder
— MD or DAT deck
For connection details, see page 20.
Select “DOLBY DIGITAL” and “DTS” after
setting “DIGITAL OUT” to “ON.”
x DOLBY DIGITAL
Selects the Dolby Digital signals output via
the DIGITAL OUT (OPTICAL or
COAXIAL) jacks.
Note
If you select one of the TVS settings while playing a
DVD, the player does not output Dolby Digital signals
from the DIGITAL OUT (COAXIAL and OPTICAL)
jacks (when you set “DOLBY DIGITAL” in “AUDIO
SETUP” to “D-PCM”).
x DTS
Selects if DTS signals are output via the
DIGITAL OUT (OPTICAL or COAXIAL)
jacks.
ON Normally, select this position. When
you select “ON,” set “DOLBY
DIGITAL” and “DTS.” For details on
setting these items, see “Setting the
digital output signal.”
OFF The player does not output the audio
signals via the DIGITAL OUT
(OPTICAL and COAXIAL) jacks. The
influence of the digital circuit upon the
analog circuit is minimal.
Setting the digital output signal
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
T h
OFF
STANDARD
DOLBY SURROUND
ON
D-PCM
DTS: OFF
D-PCM Select this when the player is
connected to an audio component
lacking a built-in Dolby Digital
decoder. You can select whether
the signals conform to Dolby
Surround (Pro Logic) or not by
making adjustments to the
“DOWNMIX” item in “AUDIO
SETUP” (page 74).
DOLBY
DIGITAL Select this when the player is
connected to an audio
component with a built-in Dolby
Digital decoder.
If the player is connected to an
audio component lacking a built-
in Dolby Digital decoder, do not
set this. Otherwise, when you
play the Dolby Digital sound
track, a loud noise (or no sound)
will come out from the speakers,
affecting your ears or causing the
speakers to be damaged.
OFF Select this when the player is
connected to an audio component
lacking a built-in DTS decoder. Note,
however, that the DTS signals
contained in a CD are output even if
“OFF” is selected.
ON Select this when the player is
connected to an audio component
having a built-in DTS decoder.
If the player is connected to an audio
component lacking a built-in DTS
decoder, do not set this. Otherwise,
when you play the DTS sound track,
a loud noise (or no sound) will come
out from the speakers, affecting your
ears or causing the speakers to be
damaged.