Sharp MUSIC SYSTEM DK-A1BK - Manual (Page 12)

12
DK-A1
DK-A1BK
Basic Operation
General control
To turn the power on
Press the ON/STAND-BY button to turn the power on.
Illumination light control
Press the SNOOZE/DIMMER button to adjust the brightness of the
display and LED.
Volume auto fade-in
If you turn off and on the main unit with the volume set to 27 or
higher, the volume starts at 16 and fades in to the last set level.
E SOUND control
The special sound created to enhance iPod sound as sound been
produced by CD-Audio quality.
When the E SOUND/DEMO button is pressed, the current mode
setting will be displayed. To change the setting, press the E SOUND/
DEMO button repeatedly to toggle ON or OFF. When ON is selected,
the unit will enter the E SOUND mode and adjust low bass and high
frequency automatically according to volume input.
Equalizer
When the EQ button is pressed, the current mode setting will be
displayed. To change to a different mode, press the EQ button
repeatedly until the desired sound mode appears.
Function
When the FUNCTION button on remote control is pressed, the
current function will change to different mode, press the FUNCTION
button repeatedly to select desired function.
Note:
The backup function protect the memorized function mode for a few
days should there be a power failure or the AC power cord becomes
disconnected.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode
or demonstration mode.
Volume control
Main unit and remote control
operation:
Press the VOL (+ or –) button to
increase or decrease the volume.
LED and FL bright
LED and FL dim
LED light off and FL dim
For rock music.
For pop music.
No equalization.
For classical music.
For jazz.
FLAT
ROCK
CLASSICS
POPS
VOCAL
JAZZ
Vocals are enhanced.
iPod Tuner FM ST Tuner FM mono
AUX AM