References, N clearing all the memory (reset), 3 can be operate on main unit only – Sharp MUSIC SYSTEM DK-A1BK User Manual

Page 23: Graphic, N before transporting the unit, Maintenance, N cleaning the cabinet, Specifications, N general, Table

Advertising
background image

23

DK-A1

DK-A1BK

References

Clearing all the memory (reset)

1

Press the ON/STAND-BY button to enter the power stand-by
mode or demonstration mode.

2

While pressing down the SNOOZE/DIMMER button and the
E SOUND button, press the POWER ON/STAND-BY button until
“CLEAR ALL” appears.

3

Can be operate on main unit only.

Caution:
This operation will erase all data stored in memory including clock,
alarm settings and tuner preset.

Before transporting the unit

Remove the iPod from the unit. Then, set the unit to the power stand-
by mode. Carrying the unit with iPod left docked might damage both
the unit and the iPod.

Maintenance

Cleaning the cabinet

Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.

Caution:

Do not use chemicals for cleaning (gasoline, paint thinner, etc.). It
may damage the cabinet finish.
Do not apply oil to the inside of the unit. It may cause malfunctions.

Specifications

As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification
figures indicated are nominal values of production units. There may
be some deviations from these values in individual units.

General

Tuner

Power source

AC 120 V, 60 Hz

Power
consumption

29 Watts

Output
power

Front Speakers: 2 watts minimum RMS per
channel into 12 ohms from 50 Hz to 20 KHz,
10% total harmonic distortion.
Subwoofer: 5 watts minimum RMS per chan-
nel into 8 ohms from 30 Hz to 250 Hz, 10%
total harmonic distortion.

Speaker

1-way type light-up speaker system
Front Speakers: 2-1/2" (6.5 cm) - 12 ohms -
Full Range
Subwoofer: 4" (10 cm) - 8 ohms - Woofer

Speaker maximum
input power

Front Speakers: 4W/Channel
Subwoofer: 10W/Channel

Speaker
rated
input power

Front Speakers: 2W/Channel
Subwoofer: 5W/Channel

Output
terminals

Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Video output: 1Vp-p

Input
terminals

Auxiliary (audio signal):
500 mV/47 k ohms

Dimensions

Width: 15-3/4" (400 mm)
Height: 5-3/4" (145 mm)
Depth: 9-7/8" (251 mm)

Weight

9.5 lbs. (4.3 kg)

Frequency range

FM: 87.5 - 108.0 MHz
AM: 530 - 1,720 kHz

Advertising
This manual is related to the following products: