Schumacher SC-8010A User Manual

Page 15

Advertising
background image

15

TROUBLESHOOTING

Performance problems often can be corrected by the user. Please read through this chart

for a possible solution to common problems.

PROBLEM

POSSIBLE CAUSE

SOLUTION

The battery is connected

and the charger is on,

but isn't charging.

The charger is in tester

mode, not charger mode.

Press the CHARGE

START button to activate

charging and select a

charge rate.

Indicator lights are lit in

an erratic manner not

explained in the “Using

Your Battery Charger”

section.

You might have acciden-

tally activated a special

diagnostic mode.

The charger may be

defective.

Make sure nothing is

touching the control

panel, then unplug the

charger and plug it in

again.
Return to place of pur-

chase for replacement.

The DIGITAL DISPLAY

always flashes before

the battery is completely

charged.

The incorrect BATTERY

TYPE may have been

selected.
This will happen if the

battery did not reach full

charge within 24 hours.

May be due to a very

large battery or a bank of

batteries requiring more

power than a 10A25A

amp charger can deliver

within 24 hours. The bat-

tery may also be faulty.

Reset the charger by

briefly unplugging it or

briefly disconnecting the

negative battery clip.

Select the desired rate

(SMALL or REGULAR

BATTERY) and BAT-

TERY TYPE again, if

necessary.

Engine crank time is less

than specified.

Starter motor may be

drawing more than 80

amps.

Charge the battery at the

REGULAR BATTERY

rate for 10 to 15 minutes

then crank the engine.

The green CHARGED

LED lights a few minutes

after connecting to the

battery.

The battery may be

fully charged or recently

charged, leaving the bat-

tery voltage high enough

to appear to be fully

charged.
The incorrect BATTERY

TYPE may have been

selected.

If the battery is in a ve-

hicle, turn the headlights

on for a few minutes

to reduce the battery

voltage and try charging

again.
Reset the charger by

briefly unplugging it or

briefly disconnecting the

negative battery clip.

Select the desired rate

(SMALL or REGULAR

BATTERY) and BAT-

TERY TYPE again, if

necessary.

Advertising