Speco Technologies DVR-16TT - Manual (Page 50)

User’s Manual
DVR-4TN/8TN/16TN/ 16TS/16TT Series
SPECO TECHNOLOGIES 01/06 49
4.6.6 Calling Preset Points
Follow these steps to call preset points.
• Press a Channel key to view the corresponding camera in full screen.
• Then press DOME to enter dome control mode.
• Press 2 to view the dome control Hint Screen; press 2 again to toggle the
Hint Screen.
• Press 1 to access the Set/Go Preset function.
Dome Preset
Index
1
2
3
4
5
6
7
8
9
Set Preset
NO
NO
NO
NO
NO
NO
NO
NO
NO
Go Preset
NO
NO
NO
NO
NO
NO
NO
NO
NO
• Use UP / DOWN keys to select the desired preset number from the menu.
• Change the <Go Preset> of the selected preset number to <YES>, and
press ENTER to call the preset point.
• Now the selected dome camera rotates to the preset position
automatically.
5. Advanced System Configuration
The detailed functions and settings of the DVR-4TN/8TN/16TN/16TS/16TT
series can be set by using the hierarchical OSD menu. This chapter describes
the menu items and options in the OSD menu.
To enter the Main menu, press MENU and then enter Administrator or User
password. The default passwords are shown in the following table. The same
default passwords are used for entering the remote viewing software
SpecoRemote TM .
Administrator Password User Password
1234 4321
It is strongly recommended to change the passwords to prevent unauthorized
access to the unit.