Shindaiwa F222 - Manual (Page 5)

5
Product Description
T dry weight
(less cutting attachment) ...........................................10.8 lb./4.9 kg
F dry weight
(less cutting attachment) ...........................................10.8 lb./4.9 kg
Engine model ........................................................................... SE
Engine type ................................................................-cycle catalyst
Bore x stroke ............................................. 1.3 x 1.1 in./33 x 8 mm
Displacement ........................................................ 1.5 cu. in./3.9 cc
Maximum power .......................................................... 1 HP/0.8 kW
@ 8000 rpm (min -1 )
Fuel/oil ratio .............................. 50:1 with ISO-L-EGD or JASO FC
class -cycle mixing oil*
Carburetor type ...........................................TK TZ, diaphragm-type
Fuel tank capacity .................................................... 1.0 oz./60 ml
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit and inspect unit and components for
any damage.
Specifications are subject to change without notice.
Ignition ........................ One-piece electronic, transistor-controlled
Spark plug ............................................................................BPMR6A
Air cleaner type ........................ Non-reversible foam filter element
Starting method ....................................................................... Recoil
Stopping method ............................................................ Slide switch
Transmission type ............................. Automatic, centrifugal clutch
w/bevel gear
EPA Emission Compliance Period** ........................... Category B
** The EPA emission compliance referred to on the emission compliance label
located on the engine, indicates the number of operating hours for which the
engine has been shown to meet Federal emission requirements. Category
C = 50 hours (Moderate), B = 15 hours (Intermediate) and A = 300 hours
(Extended).
Engine and shaft assembly
Cutting attachment shield
Cutting attachment
Kit containing cutting attachment shield,
mounting bracket and hardware, this
owner’s/operator’s manual and tool
kit for routine maintenance. Tool kits
vary by model and may include a spark
plug/screwdriver combination wrench,
and a scraper.
■
■
■
■
This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.
*meets or exceeds these specifications and is
recommended for all Shindaiwa products.
IMPORTANT!
The terms “left”, “left-hand”, and “LH”;
“right”, “right-hand”, and “RH”; “front” and
“rear” refer to directions as viewed by the
operator during normal operation.
Using the accompanying illustrations as
a guide, familiarize yourself with this unit
and its various components. See Figure 4.
Understanding your unit helps ensure top
performance, long service life, and safer
operation.
WARNING!
Do not make unauthorized
modifications or alterations to any of
these units or their components.
Figure 4
Specifications
F222
Outer Tube
Trimmer Head
Grip
Cutting
Attachment Shield
Shaft case
Handle
Throttle
Trigger
Ignition
Switch
Fuel
Tank
T222
Outer Tube
Trimmer
Head
Grip
Cutting
Attachment Shield
Gear case
Handle
Throttle
Trigger
Ignition
Switch
Fuel
Tank