Shindaiwa F222 - Manual (Page 7)

7
26013
F222
Trimmer Head
Install the Trimmer Head.
Turn the trimmer over so that the gear
case output shaft faces UP.
Remove and discard the black plastic
protective cap from the output shaft. See
Figure 10.
Rotate the holder until the hole in the
holder aligns with the notch on the
gear case. Use the long end of the hex
wrench to lock the holder and output
shaft. See Figure 10.
Remove the hex wrench.
1.
.
3.
4.
5.
Adjust the trimmer line length to reach
no further than the line cutter on the
cutting attachment shield. Trim to the
correct length if necessary.
6.
Assembly
Figure 10
The unit should now be
completely assembled and ready
for use with a trimmer head.
Cutting Attachment Shield
Assembly and Adjustments
WARNING!
NEVER operate this unit without
the cutting attachment shield installed
and tightly secured!
Figure 9A
Figure 9B
T222
Install the shield and clamp as shown in
figure 9B.
Align the hole in the outer tube with the
locator on the cap; install the two ()
screws finger tight.
Tighten the screws alternately to secure
the cutting attachment shield in place.
1.
.
3.
Install the Cutting Attachment
Shield T222.
Insert the cutting attachment shield
between the outer tube and the cutting at-
tachment mounting plate. See Figure 9A.
1.
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-head
cap screws.
NOTE:
It may be necessary to loosen the
retaining nut and clamp screw to adjust
cutting attachment shield mounting plate.
Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws. See Figure 9A.
.
Tighten the four socket-head cap screws
to secure the cutting attachment shield.
Re-tighten clamp screw and retaining nut.
3.
4.
Install the Cutting Attachment
Shield F222.
WARNING!
A standard grass trimmer
with a loop handle should NEVER be
operated with blade-type attachments.
Cutting
Attachment
Shield
Outer
Tube
Socket-
Head Cap
Screw
Bracket
Shim
Clamp
Screw
Shim
Retaining
Nut
Cutting Attachment
Mounting Plate
Line Cutter
Hex
Screws
Nuts
Outer Tube
Screws
Cutting
Attachment
Shield
Cap
Locating Hole
Figure 9C
Holder
Output
shaft
Retaining
Plug
Hex Wrench