Schwinn none - Manual (Page 24)

12
Reflectors
Your bicycle is supplied with one front (white), one rear (red), two wheel (white), and two pedal (orange)
reflectors. These are an important safety and legal requirement, and should remain securely fitted and in good, clean condi-
tions at all times. Periodically, inspect all reflectors, brackets and mounting hardware for signs of wear or damage. Replace
immediately if damage is found. Some bicycles will require you to install your reflectors onto your bicycle. Please refer to the
following section for instructions on all the types of bicycle reflectors.
Fork Mount Reflector Bracket Assembly
First insert one washer onto the hex bolt and insert hex bolt through the reflector
bracket and then through the fork. Next, insert a second washer onto the bolt and
thread a hex nut onto the bolt behind the fork. Tighten bolts until snug, making sure
the reflector is in an upright position. See diagram at the right.
Front Reflector Mount with Caliper Brake Assembly
First remove the hex nut from the back of the fork and pull the brake from the fork.
Insert a washer and the reflector bracket on to the caliper bolt. Insert the caliper bolt
back into the fork and secure firmly with a washer and the hex nut. Finally, adjust the
reflector such that it is in an upright position. See diagram at the right.