Schwinn none - Manual (Page 25)

13
Seat and Handlebar Mounting Reflectors
First attach the reflector to the reflector bracket with the reflector screw, see the top
diagram. Next, remove the clamp screw and open the clamping reflector bracket.
Place clamping reflector bracket around the handlebar or seatpost. If the clamp is
too loose, insert the shim inside of the clamp. Tighten the clamp screw to hold
reflector assembly in place, see the second diagram. Finally, adjust the reflector
assembly in place. Finally, adjust the reflector such that it is upright and facing away
from the bike.
Chainstay Mount Reflector Bracket Assembly
first insert one washer onto the hex bolt and insert hex bolt through the reflector
bracket and then through the chainstay bridge. Next, insert a second washer onto
the bolt and thread a hex nut onto the bolt behind the chainstay bridge. Tighten
bolts until snug, making sure the reflector is in an upright position. See diagram at
the right.