SMC Networks SMC EZ Card 1000 SMC9452TX - Manual (Page 28)

I
NSTALLING AND
C
ONFIGURING
N
ETWORK
D
RIVERS
2-6
Novell NetWare Installation
NetWare Server 5.0
Installing the LAN driver is part of the NetWare installation process.
Use the following instructions with those in the NetWare installation
manual to install the driver. You will need the SMC SuperDisk
during this procedure. Shut down your computer and install the EZ
Card 1000 network card in a PCI slot. Connect the card to the
network using UTP cable.
1. Turn your computer on and boot it to the NetWare 5.0 console
prompt.
2. At the NetWare console prompt enter the command “load
nwconfig” to start the install utility. The Installation Options
dialog box is displayed.
3. Select the Driver Options menu item and press enter. The Driver
Options dialog box is displayed.
4. Select the Configure Network Drivers menu item and press
enter. The Additional Driver Actions dialog box is displayed.
5. Insert the SMC SuperDisk driver diskette into the “A” drive.
6. Select the “Load an additional driver” menu item option and
press Enter. The “Select a driver” dialog box is displayed. Press
the “Ins” key to install an unlisted driver. A dialog box is
displayed indicating the A drive will be scanned for drivers.
Press Enter to continue.
7. Press Enter to select the SMC9452.LAN from the “Select a driver
to install” dialog box. A message asking if you want to copy the
driver is displayed. Select “Yes” to continue. The device driver
is copied.