SUPER MICRO Computer AS1020S-8 - Manual (Page 54)

5-20
AS1020S-8 User's Manual
SCSI Controller Enable/
Disable
Jumper JPA1 is used to enable or dis-
able the Adaptec AIC-7902W SCSI
controller. The default setting is on pins
1-2 to enable SCSI. See the table on
right for jumper settings.
SCSI Enable/Disable
Jumper Settings (JPA1)
Both Jumpers Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SCSI Termination Enable/
Disable
Jumpers JPA2 and JPA3 are used to
enable or disable termination for SCSI
channels A and B, respectively. The
default setting is open to enable termi-
nation. See the table on right for pin
defi nitions.
Note: In order for the SCSI drives to
function properly, please do not change
the default setting (enabled) set by the
manufacturer.)
SCSI Term. Enable/Disable
Jumper Settings (JPA2/JPA3)
Jumper Setting Defi nition
Open Enabled
Closed Disabled
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Power Force On
JPF allows you to enable or disable the
Power Force On function. If enabled,
system power will always stay on. If
disabled (the default setting), the user
needs to depress the power button to
power up the system.
Power Force On
Jumper Settings (JPF
Jumper Setting Defi nition
Closed Force On
Open Disabled