Scag Power Equipment SWZU - Manual (Page 22)

18
Electric storage battery fluid contains sulfuric
acid which is POISON and can cause SEVERE
CHEMICAL BURNS. Avoid contact of fluid with
eyes, skin, or clothing. Use proper protective gear
when handling batteries. DO NOT tip any battery
beyond 45° angle in any direction. If fluid contact
does occur, follow first aid suggestions below.
BATTERY ELECTROLYTE FIRST AID
EXTERNAL CONTACT - Flush with water.
EYES - Flush with water for at least 15 minutes
and get medical attention immediately.
INTERNAL - Drink large quantities of water. Follow
with Milk Of Magnesia, beaten egg, or vegetable
oil. Get medical attention immediately. In case of
internal contact, DO NOT give fluids that would
induce vomiting.
WARNING:
Charging the Battery
DO NOT charge a frozen battery. It may explode and
cause injury. Let the battery warm before attaching a
charger.
Whenever possible, remove the battery from the mower
before charging.
Unplug charger before connecting or disconnecting from
the battery. Refer to the battery charger’s manual for
specific instructions.
Under normal conditions the engine’s alternator will have
no problem keeping a charge on the battery. If the
battery has been completely discharged for a long period
of time, the alternator may not be able to recharge the
battery, and a battery charger will be required.
Charging rates between 3 and 50 amperes are
satisfactory if excessive gassing or spewing of
electrolyte does not occur or the battery does not feel
excessively hot (over 125°F). If spewing or gassing
occurs or the temperature exceeds 125°F, the charging
rate must be reduced or temporarily stopped to permit
cooling.
Jump Starting
BATTERIES PRODUCE EXPLOSIVE GASES.
Charge the battery in a well ventilated space so
gases produced while charging can dissipate.
WARNING:
1. The booster battery must be a 12 volt type. If a
vehicle is used for jump starting, it must have a
negative ground system.
2. When connecting the jumper cables, connect the
positive cable to the positive battery post, then
connect the negative cable to the negative battery
post.
CLEANING THE MACHINE
1. After each use, wash the mower and cutter deck.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
2. Do not spray electrical components.
3. Repair damaged metal surfaces using Scag touch-up
paint (P/N 48521) available from your authorized
Scag dealer. Wax the mower with an automotive
paint wax for maximum paint protection.
CAUTION:
Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
Wear protective clothing and use insulated tools