Sharp PG-MB60X - Manual (Page 31)

-27
Connections
Controlling the Projector by a Computer
When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS-232C adaptor
(optional: AN-A1RS) and an RS-232C serial control cable (cross type, commercially available), the computer
can be used to control the projector and check the status of the projector. Refer to the “SETUP GUIDE”
contained on the supplied CD-ROM for details.
When connecting to a computer using an RS-232C serial control cable and a DIN-D-sub RS-
232C adaptor
Note
• The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the
operation manual of the computer for details.
• Refer to page 4 of the “SETUP GUIDE” contained on the supplied CD-ROM for “RS-232C Specifica-
tions and Commands”.
Info
• Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This may
damage your computer or projector.
• Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This
may damage your computer.
Computer
To RS-232C terminal
RS-232C serial control cable (cross type, commercially available)
To RS-232C terminal
DIN-D-sub
RS-232C adaptor
(optional: AN-A1RS)