Sharp PG-MB60X - Manual (Page 40)

-36
Resize Mode
Press on the remote control.
• Pressing changes the display as shown on
pages 36 and 37 .
• To return to the standard image, press while
“ RESIZE ” is displayed on the screen.
• This function can also be accessed from the OSD
menu (see page 49 ).
This function allows you to modify or customize the resize mode to enhance the input image. Depend-
ing on the input signal, you can choose “NORMAL”, “DOT BY DOT”, “BORDER” or “STRETCH” image.
COMPUTER
STRETCH
Output screen image Input Signal
Image type NORMAL DOT BY DOT BORDER
4:3 aspect ratio
4:3 aspect ratio
4:3 aspect ratio
5:4 aspect ratio
16:9 aspect ratio
: Cutout area on which images cannot be projected.
: Area where the signals are off screen. * Mode for projecting an image with the original aspect ratio without cutting any portions.
* * *
* *
* *
* *
*
Computer
Resolution
lower than
XGA
XGA
Resolution
higher than
XGA
1280 × 720
SXGA (1280 × 1024)
4:3 aspect ratio
Other aspect ratios
SVGA (800 × 600)
XGA (1024 × 768)
SXGA (1280 × 960)
SXGA+ (1400 × 1050)
SXGA (1280 Ч 1024)
1280 Ч 720
1024 Ч 768
960 Ч 768
—
800 Ч 600
—
1280 Ч 960
1400 Ч 1050
1280 Ч 1024
—
768 Ч 576
720 Ч 576
—
1024 Ч 576
960 Ч 576
1024 Ч 576
NORMAL DOT BY DOT BORDER STRETCH
RESIZE button
UNDO button
MOUSE/Adjustment
button ('/"/\/|)
Image Projection
Note
• If “RESIZE” is displayed when you have set “DOT BY DOT” and signals having a higher resolution than XGA are
being input, you can move the image so that it appears entirely within the panel by using the adjustment buttons
('/"/\/|) on the remote control. (However, this does not apply when you have set “Resize” from the OSD menu.)