Star Micronics SP300 Series - Manual (Page 53)

– 49 –
7-6. Control Codes Used for Peripheral Units
FUNCTION Adjust drive pulse width for peripheral unit 1
CODE <ESC> <BEL> n1 n2
(1B)
H
(07)
H
n1 n2
DEFINITION RANGE 1 n1 127, 1 n2 127 (default setting n1 = n2 = 20)
OUTLINE Adjusts drive pulse width for peripheral devices requiring
other than standard 200 ms pulse time and delay time
Energizing time = 10
×
n1 (ms)
Delay time = 10
×
n2 (ms)
Executed by <BEL>, <FS> codes.
NOTE Adjustment is not necessary for standard cash drawers in the
U.S.A. market.
FUNCTION Deferred drive command for peripheral unit 1
CODE <BEL>
(07)
H
OUTLINE Executes drive pulse for peripheral unit 1 (deferred).
FUNCTION Immediate drive command for peripheral unit 1
CODE <FS>
(1C)
H
OUTLINE Executes drive pulse for peripheral unit 1 (immediate).
This code differs from the <BEL> code as follows:
When the printer receives an <FS> code, the command is
executed immediately. The <BEL> code is stored in the data
buffer in the same manner as other codes, and executed in the
order in which they are received.
ON
OFF
10
×
n 1 (ms) 10
×
n 2 (ms)
Printing and paper feed
are prohibited.