Smarthome NSTEON KEYPADLINK 2486D - Manual (Page 12)

INSTEON KeypadLinc V2 Dimmer User’s Guide
3. Cap the other TRAVELER house wire. The other
TRAVELER wire, usually red, will not be used, so put a wire
nut on the end of it.
4. Cap the red LOAD wire from the KeypadLinc Secondary.
Put a wire nut on the end of the KeypadLinc Secondary’s LOAD
wire to ensure that it won’t connect to anything.
5. Connect the KeypadLinc Secondary’s NEUTRAL Wire.
Locate the group of NEUTRAL wires, usually white, in the rear
of the box. The old switch should not have been connected to
the NEUTRAL wires, but KeypadLinc Dimmer requires this
connection in order to draw a small amount of power for itself.
Connect KeypadLinc Secondary’s white NEUTRAL wire to the
other NEUTRAL wires with a wire nut.
Page 12 of 38