About x10 scene address programming, Remotely setting an x10 scene address and on-level, Remotely removing an x10 scene address – Smarthome NSTEON KEYPADLINK 2486D User Manual
Page 28: As described in the sections rem, Setting an x10 scene address an
INSTEON KeypadLinc V2 Dimmer User’s Guide
4. Send the following X10 Address sequence to lock in the new Ramp Rate:
5. KeypadLinc Dimmer will flash the light it is wired to and blink its LED, indicating that the Ramp Rate
has been set for the X10 Primary Address.
About X10 Scene Address Programming
KeypadLinc Dimmer can be a member of up to 255 X10 Scenes. An X10 Scene Address is just another
X10 address like the X10 Primary Address. When an X10 ON command is sent to an X10 Scene
Address, every X10 Scene-enabled module with that X10 Scene Address will turn on to its independent
On-Level at its independent Ramp Rate. Sending an X10 OFF command to an X10 Scene Address will
turn off all modules that are members of that X10 Scene, each at its independent Ramp Rate. X10
Scene-enabled modules will react to DIM and BRIGHT commands after the X10 Scene Address is sent.
However, they will ignore ALL ON and ALL OFF commands for the X10 Scene Address.
Remotely Setting an X10 Scene Address and On-Level
1. Using an X10 Controller, send the CLEAR Sequence:
2. Set the On-Level for the X10 Scene Address by adjusting KeypadLinc Dimmer’s brightness using its
on/off buttons or any Controller. If you skip this step, the current On-Level will be used. A scene can
trigger KeypadLinc Dimmer to go off by setting the On-Level to 0%.
3. Send the following X10 Address sequence:
4. Send the desired X10 Scene Address (house code and unit code) to lock in the new On-Level and
X10 Scene Address.
5. KeypadLinc Dimmer will flash the light it is wired to, indicating that the X10 Scene Address and On-
Level have been set up.
Remotely Removing an X10 Scene Address
1. Using an X10 Controller, send the CLEAR Sequence:
Bright-
ness
Level
Ramp
Rate in
Seconds
Bright-
ness
Level
Ramp
Rate in
Seconds
Bright-
ness
Level
Ramp
Rate in
Minutes
100%
0.1
65%
26
29%
2.5
97%
0.2
61%
28
26%
3.0
94%
0.3
58%
30
23%
3.5
90%
0.5
55%
32
19%
4.0
87%
2.0
52%
34
16%
4.5
84%
4.5
48%
38
13%
5
81%
6.5
45%
43
10%
6
77%
8.5
42%
47
6%
7
74%
19.0
39%
60
3%
8
71%
21.5
35%
90
0%
9
68%
23.5
32%
120
O16
P16
N16
M16
O16
O16
N16
M16
P16
M16
M16
N16
O16
P16
O16
N16
M16
P16
M16
2. Send KeypadLinc Dimmer’s X10 Primary Address (house code and unit code).
Page 28 of 38