Smarthome NSTEON KEYPADLINK 2486D - Manual (Page 7)

INSTEON KeypadLinc V2 Dimmer User’s Guide
Attach Six Button or Eight Button Plate
Each KeypadLinc V2 Dimmer is packaged with a six key and an eight key button plate.
• The six key button plate provides a dedicated load ON button at the top of the switch, a dedicated
load OFF button at the bottom, and four programmable secondary keys between the ON and
OFF buttons.
• The eight key button plate provides a dedicated load ON/OFF button in the top left-most position
of the switch, and seven programmable
secondary buttons.
Attach the desired plate to the switch body by aligning
the plastic tabs and snap into place. Proceed with the
physical installation of KeypadLinc Dimmer.
NOTE
Note: For proper operation, KeypadLinc Dimmer must be programmed to operate in six key or
eight key mode, corresponding to whichever plate is attached. Factory default is six key mode.
Please see section titled “Configure For Six or Eight Button Operation” for instructions.
Button Nomenclature
Since KeypadLinc Dimmer has removable button labels, it can become confusing when trying to refer to a
specific button of the six available (or eight buttons when the eight button key plate is installed). Refer to
the following diagrams for button “names”.
OFF
A B
C D
ON B A
C D
E F
G H
SIX BUTTON EIGHT BUTTON
Page 7 of 38