Sharp AR-507 - Manual (Page 124)

7-10
CHAPTER
7
Staple cartridge replacement
The message “ SLIDE THE FINISHER AWAY FROM THE COPIER
AND ADD STAPLES. ” will appear when the staple cartridge is empty.
Replace the staple cartridge as follows:
1 While holding the finisher release lever, slide the finisher
away from the copier.
2 Lower the lock lever to unlock the stapler unit.
3 Turn the stapler unit to face up.
4 Hold the staple box release lever to unlatch the staple
box.
5 Remove the staple box.
6 Remove the empty staple cartridge from inside the
staple box.
7 Insert the new staple cartridge into the box until it clicks
in place.
● Insert the new cartridge by aligning the arrows on the cartridge
with those on the box. Check that the cartridge locks in place by
pulling it slightly.
● The cartridge holds 5,000 staples.
OPTIONAL EQUIPMENT
Finisher (AR-FN3)
FINISHER (AR-FN3)