Star Micronics LC-6211 - Manual (Page 27)

Entering the EDS Mode 21
Entering the EDS Mode
❏
Turn off the printer.
❏
Make sure that paper is loaded in the printer.
❏
While holding down the control panel’s SET/EJECT/PARK button, turn
the printer back on.
This causes the following message to be printed.
Note:
The paper is not fed after the message is printed, so you will have to open up
the printer’s front cover to read it.
❏
Press SET/EJECT/PARK to answer “Yes” or LINE FEED to answer
“No” for each option as it appears on the printout. Each time you reply,
printer prints the next setting.
❏
To jump to the next category at any time, press ON LINE .
❏
After you are finished making the EDS settings you want, hold down ON
LINE and press LINE FEED .
This exits the EDS Mode and registers all of the changes you have made.