Sony RDR-GX210 - Manual (Page 75)

75
Se
tti
n
gs
a
nd
Adj
u
st
m
e
n
ts
[MPEG] (DVD VIDEO only)
Selects the type of MPEG audio signal when using
the DIGITAL OUT (OPTICAL or COAXIAL)
jack.
[Sampling Freq.] (DVD VIDEO only)
Selects the sampling frequency of the audio
signal.
[Audio DRC] (Dynamic Range Control) (Dolby
Digital DVDs only)
Makes the sound clear when the volume is turned
down when playing a DVD that conforms to
[Audio DRC]. This affects the output from the
following jacks:
– LINE 2 OUT (AUDIO L/R) jacks
– LINE 1-TV jack
– LINE 3/DECODER jack
– DIGITAL OUT (OPTICAL or COAXIAL) jack
only when [Dolby Digital] is set to [D-PCM]
(page 74).
[Vocal] (Karaoke DVD only)
Mixes karaoke channels into normal stereo.
This function is effective for multi-channel
karaoke DVDs only.
[ PCM ] Select this when the recorder is
connected to an audio component
without a built-in MPEG decoder.
If you play MPEG audio sound
tracks, the recorder outputs stereo
signals via the DIGITAL OUT
(OPTICAL or COAXIAL) jack.
[ Bitstream ] Select this when the recorder is
connected to an audio component
with a built-in MPEG decoder.
[ 48kHz ] The audio signals of DVD
VIDEOs are always converted to
48 kHz/16 bit.
[ 96kHz ] All types of signals, including
96 kHz/24 bit, are output in their
original format.
[ Off ] Normally select this.
[ On ] Makes low sounds clear even if
you turn the volume down.
[ Off ] Does not mix karaoke channels
into normal stereo. You can turn
off the guide vocal on a multi-
channel DVD.
[ On ] Normally select this.