Sharp FODC525 - Manual (Page 92)

Sending an Image Using a Rapid Key or Speed Dial Number
90
8
Press . The document is scanned and transmitted.
START/
ENTER
Sending an Image Using a Rapid Key or
Speed Dial Number
Sending an image using a Rapid Key
Use this procedure to scan a document and send the image to an E-mail, FTP,
or Desktop destination that has been stored in a Rapid Key.
Important: To use this procedure, the setup procedures outlined on page 74
must be completed. In the case of Scan to E-mail, this includes setting a
default sender as explained in the procedure beginning on page 85 of this
manual.
♦
If you are sending the image to an e-mail destination and need to change
the subject, use the procedure on page 85.
1
Load the document(s).
•
SEND READY will appear in the
display.
•
Press and/or to set
the resolution and contrast if needed.
The default resolution is FINE. Note
that STANDARD and SUPER FINE are
primarily for faxing and are not
recommended for scanning.
2
Press the appropriate Rapid Key.
•
The name of the recipient will appear in the display. (If the destination is not
correct, press .)
•
If the destination is an FTP or Desktop destination, or if the destination is
an e-mail destination and you don’t need to enter a message or change any
of the e-mail options, this completes the procedure.
RESOLUTION CONTRAST
STOP
all.book Page 90 Thursday, May 13, 2004 8:51 AM