Slant/Fin GF-211D User Manual

Page 7

Advertising
background image

CLEANING INSTRUCTIONS

Failure to perform the necessary cleaning steps will damage unit.
1. Before cleaning, set CONTROLS to “OFF” position and unplug unit.

2. Remove water tank from humidifier base, and drain water from tank.

3. Allow at least 15 minutes for the hot water to cool after shutting unit “OFF”

before moving base, or removing mineral absorption pad. Remove mineral
absorption pad from hot water reservoir using tweezers or tongs to prevent
burns from hot water. When the cleaning procedure is completed, replace
mineral absorption pad. To drain water from humidifier base, grasp with
both hands and tilt to the side, draining water into the sink. BE CAREFUL
NOT TO HAVE DRAINING WATER FALL INTO CONTROLS OR VENT
OPENINGS. DO NOT drain in any manner other than indicated. WARN-
ING: DO NOT place directly under running faucet. Turn the base upside
down and remove the cap by turning it counterclockwise. Clean out any for-
eign matter that has accumulated inside the fitting from which the cap was
removed. After cleaning, replace this cap tightly by hand. Pour a small
amount of water into the hot water reservoir and check for leaks from this
cap under the base.

4. Pour about 1 cup of white vinegar into either reservoir and allow it to soak

for only 20 to 30 minutes.

5. Hold the base of the humidifier over the sink and tilt it on its side to empty

the vinegar. Fill the cold and hot water reservoirs with clean, warm water to
remove all traces of the vinegar. Remove any buildup of minerals in the hot
water reservoir using a small brush, such as a toothbrush. NOTE: The
buildup is due to water hardness. The harder your water, the more often
this maintenance will be needed. Empty all of this water by turning the unit
on its side.
DO NOT ALLOW WATER TO ENTER THE BOTTOM OF THE HUMIDIFIER
BASE OR ANY OTHER OPENINGS, OR IMMERSE THE CORD AND PLUG.

6. Disinfect the water tank using a solution of one teaspoon of household chlo-

rine bleach in 1 gallon of water. Let the solution sit for 20 minutes, swishing
every few minutes to wet all surfaces. Empty the tank completely; rinse
thoroughly until all of the bleach smell is gone. Fill the tank with fresh, cool
water and replace it onto the humidifier base.

7. NEVER use any metal or hard objects to clean plastic parts which may

cause scratching of the plastic parts. NEVER use gasoline, kerosene, glass
cleaner, furniture polish, paint thinner or other household solvents to clean
any part of the humidifier.

8. Each day the reservoir and tank should be drained, rinsed and refilled with

fresh tap water.

7

GF-211D_OM_EFS.qxd 6/20/06 11:29 AM Page 7

Advertising