Sundance Spas ALTAMAR 880 - Manual (Page 57)

Page 51
880 SERIES
13.5 Main Control Panel Lock
To help prevent unauthorized use of your hot tub, the Sentry controls
incorporate a unique panel locking system which disables the controls on
the panel.
• To Lock The Main Control Panel: Press (diSPLAY)
,
(MOde) , and (UP) buttons within five seconds
each. A padlock symbol will appear on the LCD screen.
With the panel locked, all components are disabled from manual
activation and the only settings that can be adjusted are the standard
and economy filter/heating modes and time of day. All automatic hot
tub functions will operate normally.
• To Unlock Main Control Panel: Press (diSPLAY) ,
(MOde) , and (dOWN) buttons within five sec-
onds. The lock symbol will disappear. All buttons are now active.
13.6 Temperature Setting Lock
The hot tub’s temperature setting can be locked to prevent unauthorized
changes. When locked, all other hot tub buttons and functions operate
normally.
• To Lock Temperature Setting: Press (UP)
or
(dOWN) button to display temperature setting, then
immediately press the (diSPLAY) , (MOde) ,
and (UP) buttons within five seconds each. A padlock symbol
will appear on the screen.
• To Unlock Temperature Setting: Press (UP) or
(dOWN) button to display temperature setting, then
immediately press the (diSPLAY) , (MOde) ,
and (dOWN) buttons within five seconds.
13.7 Programming the Change Filter reminder
Your new hot tub is equipped with a programmable “Change Filter”
reminder icon that flashes on the control panel display after a
specified number of days. It is designed to remind you to perform
routine filter system maintenance on a regular basis but does not affect
hot tub operation in any way. The “Change Filter” reminder icon must be
reset at each interval. It offers a selectable range from 10-120 days or
can be disabled (turned off). We recommend an initial setting of 30 days
(1 month) to remind you of this important maintenance step.
Note: This reminder must be reset at each filter inspection/replacement
interval. Refer to Section 14.1 for filter replacement instructions.
Programming instructions
1. Press the (CYCLe) button two times (in Standard Mode, six
times in Economy Mode). The main display reads “FIL” indicating the
“Change Filter” display program has been accessed.
LOCKED
LOCKED