Sony PEGA-WL100 - Manual (Page 27)

27
12
Tap V of [ch] below [Adhoc], and select a channel.
Be sure to select the same channel for both your CLIÉ handheld
and the other communication device. Select a channel from 1 to
11.
13
Tap [Advanced Setup] in the lower right corner of the
screen.
14
Tap the checkbox of [Auto] in [IP Address], and remove
the tick.
The IP address input screen appears.
Note
Ad-hoc mode may not be established if “Auto” is checked.
The connection works only when both of the PC without DHCP and CLIÉ
handheld select “Auto”. Most of the time, user has to enter static IP on CLIÉ
handheld for the Ad-hoc mode.
Continued on next page