Woodstock W1683 - Manual (Page 12)

8
The following is a description of the components
shipped with the Shop Fox
® W1683 20" Planer.
Should any parts be missing, examine the
packaging carefully to be sure parts are not
among the packing materials. If any key parts
are missing, contact Woodstock International,
Inc. at 360-734-3482 or by e-mail at:
[email protected].
Box Contents
1. Planer Unit
2. Dust Hood
3. Starter Switch
4. Rollers (2)
5. Handwheel
6. Hardware Bag:
(6) M6-1.0 x 12 Hex Bolts
(6) 6mm Flat Washers
(8)
1 ⁄
2
" Flat Washers
(8) M10-1.5 x 25 Hex Bolts
(1) Knife Setting Rod
(2) Knife Setting Gauge
(4) 9mm E-Clip Ring
(1) Handle
(1) 3mm Allen Wrench
(1) 4mm Allen Wrench
(1) 5mm Allen Wrench
(1) 6mm Allen Wrench
(1) 8mm & 10mm Combo Wrench
(1) 12mm & 14mm Combo Wrench
(1) 17mm & 19mm Combo Wrench
ASSEMBLY
Figure 2. Parts that need to be assembled.
Overview
Do not connect the
machine to power at this
time. The machine must
remain unplugged
throughout the entire
assembly process. Failure
to do this may result in
serious personal injury.
We have assembled most of your new planer for
you at the factory; however, the parts shown in
Figure 2 still need to be assembled after
delivery. Please take your time and try to be as
accurate as possible when following each step.
This care will provide you with better results
when you are finished.
Additional Tools Required: Besides the tools
that were included with the planer, you will also
need a Phillips ® screwdriver, a flat-head
screwdriver and a good straightedge. A set of
feeler gauges and a dial indicator will also be
necessary for the Adjustments section.