Woodstock W1683 - Manual (Page 14)

10
Figure 3. Checking roller extension with a
straightedge.
Extension Rollers
The extension roller assemblies are identical for
both the infeed and the outfeed ends of the
table. To mount these assemblies:
1. Attach an extension bar to the end of each
roller. Secure these in place with the 12mm
snap rings provided in the hardware bag.
2. Match the tapped holes on the side of the
table to the extension bars. Lightly secure in
place with the M10-1.5 x 25 hex bolts and
washers from the hardware bag.
3. The end (outside) roller is fixed in place.
Place a straightedge flat across the table
and across the rollers as shown in Figure 3.
Adjust the end roller so it is flush with the
table, and tighten the M10-1.5 x 25 hex
bolts to secure the extension bars in place.
4. The two inside rollers are mounted in
slotted holes so they can be adjusted flush
with the table and the end roller. Make
these adjustments and tighten the bolts to
secure the inside rollers in place.
The top of the rollers should now be completely
even with the top of the table. Double-check to
make sure that the rollers did not move during
the tightening process.