Sub-Zero 315W - Manual (Page 12)

12
S U B - Z E R O M O D E L 3 1 5 W I N S T A L L A T I O N
OV E R L AY PA N E L I N S T A L L A T I O N
IMPORTANT NOTE: Install screws in all the
mounting holes in the door frame. The nature
of the door panel with a narrow outer rim and
no connecting center member requires the
support provided by the glass door.
After the door panel installation is complete,
apply the cover patches or plugs provided over
the holes on the inside surface of the door.
The cover patches or plugs are part of the
insulation system on the door of the wine
cooler. Be sure to cover all the holes in
the door that were used.
The wine cooler door is made with
a sealed double wall tempered glass core.
The drill must not contact this core when
drilling. Be sure the hole is centered on
the small groove in the front of the door
frame and the drill passes squarely
through the frame. If you are inexperi-
enced with drilling, fasten the handle from
the rear of the door panel only.
P A N E L
D E S I G N
Additional panel
design information
can be found in
the Sub-Zero
Design Guide.
Check our website
at subzero.com.