Sanyo Projector - Manual (Page 33)


ENGLISH
About projector condition
Status Description
Normal ............................................................... Projector is operating normally.
Power management in operation ........... Power management is operating
Shutter management in operation ...... Shutter management is operating
Lamp failure ................................................... Lamp failure is occurring
Abnormal temperature ......................... The temperature of the projector became too high
Standby after Abnormal Temp. ........ Projector detects abnormal temp. and sets into standby mode.
Power failure ................................................ Power failure has occurred inside the projector. Projector is turned
off. Unplug the AC cord and ask servicing to a qualified service
personnel.
Power control and status check
When a security (PIN code lock) has been set on the projector, you also cannot
control it through the network. To control the projector through the network
temporarily, execute "PJ lock suspend" command to unlock the security. "PJ lock
suspend" is on setting sub menu [3] on Setting main menu. (+p.42)