Image adjustment – Sanyo Projector User Manual
Page 36
Chapter 4 Controlling the Projector
Item
Description
Contrast ................................. Adjusts picture contrast.
(0~ 63)
Brightness ............................ Adjusts picture brightness.
(0~ 63)
Color ......................................... Adjusts picture color satura-
tion. (0~ 63)
Tint ............................................ Adjusts picture hue. (0~ 63)
Color temp. .......................... Sets a color temperature
mode. (X Low, Low, Mid, High,
Adj.)
White balance
Red, Green, Blue .......... Adjusts each white balance
respectively. (0~ 63)
* When changing the value of the white balance,
the color temp. indicates "Adj."
Offset
Red, Green, Blue .......... Adjusts each offset respec-
tively. (0~ 63)
Auto picture control ..... Sets auto picture control
level. (OFF, L1, L2)
Advanced color ................ Applies improved color
adjustment with yellow
light controller. (Auto, OFF)
Sharpness ............................. Adjusts picture sharpness.
(0~ 31)
Gamma ..................................... Adjusts brightness of darker
part of the picture. (0~ 15)
Noise reduction .................Switches noise reduction mode (ON, OFF)
Progressive ..................................Switches progressive mode (OFF, ON, Film)
Reset.........................................Resets the Image adjustment to previous levels.
Store ......................................... Stores the Image adjustment values. Select an item [Image1 - Image10] from
the pull-down menu and click Store button.
Load Image mode .......... Loads the Image mode. Select an image mode from the pull-down menu
and click Load button. There may not be available mode depending on the
input mode as shown in the table left.
Image adjustment
This function is to adjust the projected picture image and save the image mode. To store
the adjusted value, click Store button, and to load the adjusted value, click Load button.
Input source
Image mode Video Computer
Standard
4
4
Cinema
4
*
Real
*
4
Dynamic
4
4
Image1 - 10
4
4
* When Edge blending is set to "ON", Auto picture control and
Advanced color are disable.
* When Color matching is set to "ON", Auto picture control,
Advanced color, Color temp., White balance and Offset are
disable.
✐
The mark "
4
" means that the available image mode in the
selected input source. The error message appears when
selecting the disabled image mode indicated with "*".