SMC Networks Barricade SMC7404BRA EU - Manual (Page 21)

I
NSTALLATION
2-6
Connect the ADSL Line
Run standard telephone cable from the wall jack providing ADSL service
to the WAN port on your Barricade. When inserting an ADSL RJ-11 plug,
be sure the tab on the plug clicks into position to ensure that it is properly
seated. If you are using splitterless ADSL service, be sure you add low-pass
filters between the ADSL wall jack and your telephones. (These filters pass
voice signals through but filter data signals out.)
Phone Line Configuration
Installing a Full-rate Connection
If you are using a full-rate (G.dmt) connection, your service provider will
attach the outside ADSL line to a data/voice splitter. In this case you can
connect your phones and computer directly to the splitter as shown below:
Figure 2-1. Installing With a Splitter
Voice
Data
Residential
Connection
Point (NID)
Plain Old
Telephone
System (POTS)
or
Ethernet
hub or switch
ADSL Router
Splitter